Short Review About All Types of Busbar Bending Machines Facilities

Short Review About All Types of Busbar Bending Machines Facilities

    Busbar bending systems are produced to facilitate

bending busbars for switch boards and switch gears manufacturers these systems are present

in 4 types:

    1-Manual busbar bending tools

    2-Hydraulic busbar bending tools

    3- Simple hydraulic busbar bending machines.

    4-Professional busbar bending machines.

    At Manual tools operator should bend busbar via hand force and it is suitable just for

small size if busbars, it could bend busbars at normal axis and measurement is possible

just with operator eyes . repeatability and accuracy depends on operator skills.

    At hydraulic

busbar bending machine and tool, We have some condition for accuracy and

repeatability but operator needs low force for doing job. This type is suitable for sites

or places that electricity is not available and for small jobs.

    Simple hydraulic busbar bending machines are a good choice for small shops or factories

that need bending busbar

processing machine in normal axis away. Measurement of angles are by mechanical or

digital angel indicators. Mostly they have “V” type head that cause two lines behind of

busbar after bending they don’t calculate spring back and operator should consider and

compensate this fault at bending process.

    Professional busbar bending machines are suitable for Professional usurers.Bending head

is powered with two routable plates to prevent any damage at surface of bus bar after

bending. It has high technology angel measurement system that calculate spring back (spring

back compensation system) and final bends adapt to desired angel with high accuracy. That’

s why at, switch gears geowy we are faced to various types of bending requirements this

machine should response to most of them.

    Edge bending mold:

    At switch gears some time designer needs to bend busbars from edge especially at

electrical keys they need more space for connection’s and edge bending allow them to have

enough space. Edge bending mold is a good solvation for this purpose and installable at

professional busbar bending machines head. It should keep two main surface of busbar to

prevent any bulge at surfaces.

    Step Mold:

    In some drawing designers need two closed bends in bus bar and it is not possible to do

job with normal head, in these cases step mold bend two bending in one step and result is

perfect.

    Twist bending mold:

    In some case direction of busbar machine

connections are not in the same directions and mostly operators have to use several

pieces of busbars. So by twist bending Mold it is possible to twist

auto busbar processing

machine up to go degree.

    Mold for short legs bens:

    This mold allow operator to bends too closed to end of busbars and

busbar mold.